What are the Dimensions of the DeeZee Specialty Series Trailer Tongue Tool Box DZ91716?
Question:
What is the width of the BASE at the back? I know the top is 34”, but the box may be located inside the tongue frame rails with about 33” clearance I.D. It has alternate support rails underneath.
asked by: Dan B
0
Expert Reply:
The DeeZee Specialty Series Trailer Tongue Tool Box item # DZ91716 measures 34" long in the back, 16" long in front, 14-1/4" wide and 18" tall. The lid measures 36" long in the back, is 15" wide, and adds 1" to the overall height.
I got these measurements from DeeZee and have linked a diagram below.
expert reply by:
Jerred H
0
DeeZee
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
DeeZee Specialty Series Trailer Tongue Tool Box - A-Frame - Aluminum - 3.71 Cu Ft - Silver
- Trailer Tool Box
- A-Frame Trailer Tool Box
- 18 Inch Tall
- Aluminum
- Small Capacity
- 14-1/4 Inch Wide
- 34 Inch Long
- Silver
- DeeZee
more information >
Continue Researching
- Article: Stability Control for Heavy Duty Vehicles
- Article: Trailer Wiring Diagrams
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: 2004 Silverado Camper Shell Wiring Recommendation
- Q&A: Gauge/Thickness of Aluminum Used on UWS Tool Box # UWS01039
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Q&A: A-Frame Battery Box Options for Ego Battery Power Station
- Q&A: How to Pick Out Brake Assemblies for Ceder Creek RE36 2011
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Location of Curt Front Hitch Installation on a 2016 Toyota 4Runner
- Article: Trailer Lighting Requirements
- Q&A: Wiring Adapter For 2009 Porsche Cayenne With 7-Way Connector Towing Trailer With 4-Pole Connector
- Q&A: Can I Use Dexter Components on Lippert Axles and Vice Versa?
- Article: Printable Trailer Bolt Hole Pattern Template
Dan B.
4/25/2024
Thanks. This is what I needed. The diagram was the source of confusion. The 14.5 measurement is shown as the length of the diagonal side, but I think it is really the measurement perpendicular to the back, not diagonal.