Tip for Mounting Wheel to Dutton Lainson Extra Offset Spare Carrier DL22145
Question:
How do you mount the wheel to the holder with the holder facing at an angle down keeping it in place to put lug nut on .
asked by: Charles W
0
Expert Reply:
Hey Charles, yeah so it would be challenging to holdup a wheel to the Dutton Lainson offset spare carrier part # DL22145 but best way would be to first get one bolt through and the nut started and then from there you can use that bolt to hold the wheel so that you can start the other bolts. It is angled like this to help create more room on the trailer.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Extra Offset Trailer Spare Tire Mount by Dutton-Lainson
- Spare Tire Carrier
- Frame Mount
- Offset Style
- 5-Bolt
- 6-Bolt
- Trailer
- 3 Inch Frame
- Dutton-Lainson
more information >
Continue Researching
- Article: Trailer Tire Sizing
- Q&A: Replacement Hub And Bearing Kit For An AL-KO 8460 Hub
- Q&A: Can Generator Be Ran While Installed on MORryde RV Generator Slide Out Tray
- Q&A: Recommended Spare Tire and Tire Carrier for Boston Whaler Boat Trailer
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Spare Tire Mounting Location on Trailer Frame
- Article: Trailer Wiring Diagrams
- Article: Printable Trailer Bolt Hole Pattern Template
- Q&A: Replacement Hand Winch Handle for my 2,500 lb. Dock Winch
- Q&A: How Far Out From the Trailer Will the Dutton Lainson Spare Tire Carrier Extend
- Q&A: Determining Towing Capacity of 2016 Toyota Highlander and Parts Needed to Tow Trailer
- Article: Performance Chips and Modules
- Article: Best Boat Trailer Jacks
- Article: How to Install E-Track in 3 Easy Steps