Availability of Fastway e2 Shank No Longer Than 9-1/2 Inches
Question:
Looking for a Shank which handles 800 Lbs TW, 2x2, 8,000 lb GTW. Used for e2 Trunnion Hitch. Total Length of Shank not to exceed 9.5. I wish your products would list the overall measurements.
asked by: Paul S
Expert Reply:
The majority of our WDH shanks have the dimensions listed either in the description or on a diagram. Regardless, 9-1/2" is very short and only one out of everything available comes close. The # AMAC1 has an overall length of 9-15/16". There is nothing shorter than this. The distance from the center of the shank holes to the center of the hitch pin hole is 6-3/4" and it has a drop of 2-5/8" and rise of 7-3/8" when used with trunnion bars. This is compatible with the Fastway e2 # FA92-00-0800.
Products Referenced in This Question
Convert-A-Ball Cushioned Weight Distribution Shank for 2" Hitches - 10,000 lbs
- Accessories and Parts
- Weight Distribution Hitch
- Shanks
- Fits 2 Inch Hitch
- Round - 3 Inch Drop
- Trunnion - 2 Inch Drop
- Round - 6 Inch Rise
- Trunnion - 7 Inch Rise
- Convert-A-Ball
more information >
Fastway e2 Weight Distribution w/ 2-Point Sway Control - Trunnion - 8,000 lbs GTW, 800 lbs TW
- Weight Distribution Hitch
- WD With Sway Control
- Some Sway
- Includes Shank
- Electric Brake Compatible
- Surge Brake Compatible
- Fits 2 Inch Hitch
- Allows Backing Up
- 600 lbs
- 700 lbs
- Fastway
more information >
Product Page this Question was Asked From
Fastway e2 Weight Distribution Shank - 12" Long - 7-3/4" Rise, 5-1/4" Drop - 1.2K TW
- Accessories and Parts
- Weight Distribution Hitch
- Shanks
- 1500 lbs TW
- 15000 lbs GTW
- Fits 2 Inch Hitch
- e2
- Round - 5 Inch Drop
- Trunnion - 3 Inch Drop
- Round - 7 Inch Rise
- Trunnion - 7 Inch Rise
- Fastway
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Would Switching a Weight Distribution Shank to A longer One Change the Height of a WDS
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Is 8 inches From Bottom of Weight Distribution System to Ground Enough Clearance
- Q&A: Measurements to Top Hole on Fastway e2 Weight Distribution Shank
- Q&A: Will the 18 Inch Long Equal-i-zer Weight Dist Shank item # EQ90-02-4500 Work w/ the E2 System?
- Q&A: Is Curt Weight Distribution Shank #17100 Compatible with Fastway Weight Distribution
- Q&A: Replacement Hardware for Fastway e2 Weight Distribution Head
- Q&A: Dimensions of the Convert-A-Ball Cushioned Weight Distribution Shank # AMAC1
- Article: How to Drain an RV Water Heater
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How Does a Trailer Hitch Coupler Work?
- Article: Trailer Couplers
- Article: How Much Solar Power Do I Need For My RV?
- Article: How (and Where) to Connect an RV Propane Grill