Fulton Jack FTJ12000101 - Distance From Center Of Bracket To Bottom Of Wheel When Retracted
Question:
Need to install a jack and is low profile trailer. Need to know measurement of jack from center of mounting to bottom of wheel at retracted height ?
asked by: Auto C
0
Expert Reply:
Hello. I was able to get the measurement for the Fulton Round Snap-Ring Swivel Marine Jack # FTJ12000101 that you requested. It is 9-3/4" from the center of the bracket to the bottom of the wheel when retracted. I made I diagram for your reference.
expert reply by:
Jesse M
0
Product Page this Question was Asked From
Fulton Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 10" Lift - Zinc - 1.2K
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Bolt-On
- With Wheel
- Fulton
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Hub with LM67048 Inner Bearing and LM11949 Outer Bearing
- Q&A: Replacement Idler Hub For Old Boat Trailer With DICO 45264 Idler Hubs
- Q&A: Can 17-RPM Lift Motor for Fan-Tastic Vent B Series Be Used Instead of 7-RPM Lift Motor
- Q&A: Will the CE Smith Roller-Style Guide-Ons Fit an EZ Loader Boat Trailer with 4 Inch Tall Frame
- Q&A: Replacement Hub for DICO 45264
- Q&A: Replacement Bearings and Seal for Freedom Axle 45264 Hub Assembly
- Q&A: Replacement Parts and Winch for a Profile 2000 Hand Winch
- Article: Where to Position the Trailer Axle?
- Article: Trailer Wiring Diagrams
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: How to Measure for Trailer Hitch Drop
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Trailer Maintenance Schedule
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)