Can New Holes Be Drilled for Ram Gooseneck Coupler Inner Tube
Question:
Would there be a problem if the tube was redrilled so the inner tube could be rotated 90 degrees so the latch faces the front.
asked by: Paul P
0
Expert Reply:
Thanks or reaching out, Paul!
If you want the handle for the Ram Gooseneck Coupler w/ Load Bearing Pin # GCSQ-25008 to be forward-facing then you'll want to weld it on in that orientation. If you were to drill a whole new set of holes in the inner tube that would make the inner tube weaker and we'll want to avoid that.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Ram Gooseneck Coupler w/ Load Bearing Pin - 8" Adjustment - Square - 2-5/16" Ball - 25K
- Gooseneck Coupler
- Coupler with Outer and Inner Tube
- Square Tube
- 25000 lbs GTW
- 2-5/16 Inch Gooseneck Ball
- Manual Latch
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: Is There a 3-1/2 Inch Per Side Inner Gooseneck Coupler Available?
- Article: Gooseneck Trailer Hitch Information and Review
- Q&A: Slipper Spring Hanger Positioning for 7,000 lb Tandem Axle
- Q&A: Replacement Hub for a UFP H-1377 on a 2004 Tahoe Boat Trailer
- Q&A: How to Determine Hanger Spacing for Tandem Axle Trailer Suspension with 26 Inch Springs
- Q&A: How to Convert Oil Bath Trailer Hubs to Grease Hubs
- Q&A: Replacement Gooseneck Coupler Options for Big Tex Trailer with 3-1/2" Square Coupler
- Q&A: Replacement Adjustment Handle for Ram Adjustable Gooseneck Coupler GCSQTW-30008
- Article: Gooseneck to 5th Wheel Adapters
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Slipper Spring Trailer Suspension System Review
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: 7 Common Questions Everyone Has About Trailer Tires