Can Fulton Bolt-On Sidewind Snap-Ring Trailer Jack # FTJ12000101 be Installed with Weld-On Plate
Question:
Do you have the weld on plate for the Fulton Trailer Jack FTJ120W0301. I have the TJ12000101 jack, and want to weld the back plate onto the trailer, rather than use the mounting brackets around the tongue of the trailer. Thanks so much for your assistance.
asked by: Lauren S
Helpful Expert Reply:
Your Fulton Round-Tube Snap-Ring Swivel Marine Jack # FTJ12000101 that comes with a bolt-on bracket can be installed using a weld-on mounting plate like the one supplied with Fulton # FTJ120W0301. The part you can use is # BDP2052000.
Products Referenced in This Question
Replacement Weld-On, Snap-Ring Swivel Plate for Bulldog Jacks - 3/8" Plunger Pin Diameter
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Mounting Hardware
- Swivel Plate
- Bulldog
more information >
Fulton Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 10" Lift - Zinc - 1.2K
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Weld-On
- With Wheel
- Fulton
more information >
Product Page this Question was Asked From
Fulton Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 10" Lift - Zinc - 1.2K
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Bolt-On
- With Wheel
- Fulton
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Replacement Weld-On, Snap-Ring Swivel Plate for Bulldog Jacks - 3/8" Plunger Pin Diameter
- Q&A: Does the Replacement Swivel Plate for a Bulldog Trailer Jack Come with Snap Rings
- Q&A: Will Replacement Swivel Ring Plate For Bulldog Jacks Fit BAL 29005 Jack
- Q&A: Replacement Hub with LM67048 Inner Bearing and LM11949 Outer Bearing
- Q&A: Replacement Idler Hub For Old Boat Trailer With DICO 45264 Idler Hubs
- Q&A: Can I Use Different Grease w/ the CE Smith Trailer Idler Hub Assembly?
- Q&A: Replacement Parts and Winch for a Profile 2000 Hand Winch
- Q&A: Replacement Bearings and Seal for Freedom Axle 45264 Hub Assembly
- Article: Where to Position the Trailer Axle?
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Choose the Right Trailer Hitch Class
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: How to Measure for Trailer Hitch Drop
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs