Parts Needed To Add 7-Way Plug To A 2011 Range Rover HSE Sport
Question:
Hi, I am looking for a 7 pin wiring kit for my 2011 Range Rover HSE Sport. The vehicle already has the factory tow hitch as an fyi, along with the mounting holes for the socket. I wasn’t sure which kit to get. Thanks in advance Mark
asked by: Mark H
Expert Reply:
Hey Mark, I can definitely help set up your 2011 Land Rover Range Rover HSE Sport with a 7-way plug. It sounds like you do not have any trailer wiring currently, so you will need the following wiring kits:
Curt Powered Tail Light Converter # C59236
Universal Installation Kit # ETBC7
These two kits will include everything needed to install a 7-way, including all of the necessary wires for an electric trailer brake controller. For that I recommend the Tekonsha Prodigy P3 # 90195, since it is our most user friendly, and reliable brake controller.
I have linked a few of our install and review videos for these products below if you want to take a look.
Products Referenced in This Question
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Universal Fit
- 4 Flat
- CURT
more information >
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Product Page this Question was Asked From
Stabilizer Jack - 6-1/4" Drop Leg Travel - 18" - 650 lbs - Qty 1
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- Stabilizer Jacks
- Steel
- 0 - 1000 lbs
- Drop Down Jack
- Bolt-On
- Weld-On
- 1 Jack
- etrailer
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Correct Replacement Parts for a Ventline VD0434 Roof Vent
- Q&A: Overall Dimensions Of The Stabilizer Jacks # TJ01RT-HD In The Stowed Position
- Q&A: Replacement AC Unit For The Carrier 68RV15102A
- Article: Trailer Lighting Requirements
- Article: Trailer Tire Sizing
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Comparing Kenda and Provider Trailer Tire in Size ST205/75R14
- Q&A: Comparing Kenda Karrier, Taskmaster and Provider Special Trailer Tires in Size ST21575R14
- Article: Most Popular Wheel Bearings
- Q&A: Load Capacity for Rackem Fitz-All Enclosed Trailer Ladder Rack
- Q&A: Can I Replace Leaf Springs With Lower Rating For Better Ride Quality