Can The Jacks on the Lippert Ground Control 3.0 Manually be Put Down?
Question:
Can you manually put jacks down on a lci system, if key board is not doing it. Had to manually retracted them when they were down
asked by: Janet
0
Expert Reply:
Yes Janet, the jacks on the Lippert Ground Control 3.0 # LC358590 can be manually put down similar to the way you retracted them. You will need the 3/8" ratchet and a short extension to fit into the drive under the rubber plug on top of the jack. Then you will be able to extend or retract the jacks as needed.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Is The Pad For The Replacement 22-1/2" Legs For The Ground Control 3.0 Welded Or Pinned In Place
- Q&A: Wiring Diagram and Fuse Location for the Lippert Ground Control 3.0 4-Point Leveling System
- Q&A: Wiring Installation for 5th Wheel Landing Gear Switch
- Q&A: Wiring Diagram for 5th Wheel Trailer Landing Gear with Red, Black, White, and Green Wires
- Q&A: Wiring Guide for Installing 5th Wheel Landing Gear Motor Switch
- Q&A: Which Lippert Ground Control 3.0 System Is Recommended for a 37' Fifth Wheel
- Q&A: Drawing Schematic of Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0
- Article: How to Raise Your Travel Trailer Height
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: How to Level Your Fifth Wheel in 3 Simple Steps (Manual or Auto-Level)
- Article: Gooseneck to 5th Wheel Adapters
- Article: Big Truck Big RV
- Article: Double-Eye Trailer Suspension System Review