How To Wire In The Pollak Starter Solenoid # PK5232401
Question:
Pollak-Accessories-and-Parts-PK5232401 are the two smaller terminals + and - pos/neg is there a email that i can send diagram of relay that i need to make suire this will work. or a text i can send pic?
asked by: Chris C
0
Expert Reply:
The two larger terminals on the sides of the Starter Solenoid # PK5232401 are for power and the two smaller terminals are for ground and tying into an ignition source. Either terminal on the front can be ground or ignition.
I did get your picture, if you can provide more details on what you're installing it on I could make sure that this solenoid would be a compatible replacement.
expert reply by:
Kevin C
0
Product Page this Question was Asked From
Starter Solenoid - SPST - 24 Volt - 100 Amp - Continuous Duty - Insulated
- Accessories and Parts
- Battery Boxes
- Switches and Solenoids
- 100 Amp
- Pollak
more information >
Continue Researching
- Q&A: Offset of Andersen Ultimate Fifth Wheel Hitch AM3200 Explained
- Q&A: Parts Needed to Allow Tow Vehicle Battery to Charge Trailer Battery While Driving
- Q&A: Power Solenoid to Control DC Power in RV
- Q&A: Installing Battery Isolation Solenoid For Trailer Battery In 2001 Dodge RAM 2500
- Q&A: Can 8 Gauge Wire Be Used in OEM Trailer Connector on a 1998 Dodge Ram 2500
- Q&A: Difference Between 3 Terminal and 4 Terminal Solenoid
- Q&A: Tapping into a 12 Volt Source on a 2001 Chevy Silverado