Can Tire Chains be Used on A 2024 Hyundai Palisade With Aluminum Wheels

Question

Question:

Looking at the Titan Chain Snow Tire Chains - Diamond Pattern - Square Link - Assisted Tensioning - Item # TC2323 chains, but my 2024 Hyundai Palisade Calligraphy, has alloy wheels. In the manual, it calls out a few requirements. Use SAE S class or wire chains. Do not use tire chains on vehicles equipped with aluminum wheels. If unavoidable, use a wire type chain. Use wire chains less than 0.59 in. 15 mm thick to prevent damage to the chains connection. Can I use these chains since I have alloy wheels? Tire Size: 245/50R20 Thank you!

asked by: Amy L

0

Expert Reply:

Yes, you can use the Titan Chain Snow Tire Chains # TC2323 with your Aluminum wheels on your 2024 Hyundai Palisade. The only reason they say that you "shouldn't" is because you could scratch the wheel. You could also always just use a set of cables like # TC3010 which won't interfere at all with your wheels.

expert reply by: Bryce D

0

Answer 1

For the 245/50-20 tires on your 2024 Hyundai Palisade I recommend the Titan Chain Snow Tire Chains #TC2323. This is a drape-over chain and will be very easy to install. Much easier than your standard ladder-style chains. You just drape the chain…

view full answer...

Answer 2

The Titan chains part #TC2323 do not auto-tension. You would need to adjust tighten them up or use tensioners part #TCMA2 to easily remove the slack in the chains.

view full answer...

Answer 3

Class S is the Society of Automotive Engineers' definition of the least amount of space that should be provided around the drive tires of any vehicle to accommodate the use of a winter traction device. A Class S tire chain meets this standard and…

view full answer...

Answer 4

I checked with Konig and can confirm that the Konig Tire Chains item #TH01594267 will fit a 265-65-R18 tire on a 2023 Chevy Colorado. These are sold in pairs. I have linked an installation video below we did on a 2020 Colorado with a similar set of…

view full answer...

Answer 5

Yes, the Konig Standard Snow Tire Chains - Diamond Pattern - D Link - XB16 #th01571255 will fit your 235/55-20 tires, but it is important to note that these chains do require at least 16mm of internal wheel well clearance on your 2021 Toyota…

view full answer...

Answer 6

Hey Kathleen, so for a set of tire chains that fits the tire size of 235/65-18 of your 2018 Toyota Highlander based on what you mentioned you'd want the Titan chains part #TC2323. These aren't expensive at all, provide great traction, are…

view full answer...

Answer 7

When using a single set of tire chains on a vehicle that is 4 wheel drive or all wheel drive you want to install the chains on the primary drive axle. Typically this will be listed in the owner's manual. But for a 4WD drive vehicle the axle to…

view full answer...

Answer 8

I did some research and I checked the owner's manual of your 2021 Toyota Highlander. You will need to use a Class S compatible snow tire chain, they are the only snow tire chains that meet your owner's manual tolerances. They are designed for…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

I am far from an expert on snowmobiles but one would have to think such a large truck with the correct tires and chains would be able to make it through up to 2' of snow assuming you have clearance on the vehicle. In regards to the type of tire…

view full answer...

Can Tire Chains be Used on A 2024 Hyundai Palisade With Aluminum Wheels

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching