How To Wire In A Furrion Vision S Camera System Side-Marker Camera

Question:

Hello. I’m installing the furrion s side marker cameras on my 2002 for pleasureway. The instructions state the yellow wiretrigger is only available for led version. Does this mean I would need to install a driver for the led turn signals to work or will it work with the two wires provided on the halogen circuit?

asked by: Christopher

Expert Reply:

What they mean is that the yellow trigger wire is only included on LED versions of the side-marker cameras # FCE48TASL. On non-LED models you wouldn't have the wire available. The yellow trigger wire would be used if the specific light you were replacing had a wire connected to the turn signal function in the junction box. You could run a wire for this as well but it's a bit of hassle once the walls are up on the trailer to run the wiring so most people just cap off the yellow wire with electrical tape. I've attached a short installation video below where I'll go over wiring at the 40 second mark.

expert reply by: Kevin C