Parts Needed to Move Trailer leaf Springs to Top of Axle on a Heartland Northtrail 28brs 2014
Question:
what all do i need to put a lift kit about 3 to 4 inches to my travel trailer
asked by: Jose S
Helpful Expert Reply:
If you have a 3 inch axle and double-eye springs all you would need to give your travel trailer about a 3 inch lift would be the Dexter Over Under kit part # K71-385-00. If you have a 2-3/8 inch axle you would need the part # K71-384-00.
Each kit comes with everything needed to flip one axle. If you have a tandem axle trailer you would need a quantity of 2 kits.
I attached a picture that shows what an over under kit does.
When lifting your trailer you need to keep in mind that the geometry of the trailer will change. You may encounter lower or heavier tongue weight, and/or the trailer may become top heavy, contributing to trailer sway and instability, especially when passing large trucks or in high winds. In these situations, it may require you to go with a weight distribution system with sway control, if you are not already using one. I have provided a video and a link to weight distributions systems for you to review.
If you have slipper springs you will need to look into taller hangers.
Products Referenced in This Question
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 2-3/8 Inch
- Single Axle
- Dexter
more information >
Product Page this Question was Asked From
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 3 Inch
- Dexter
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Raise Your Travel Trailer Height
- Q&A: How to Raise a 5th Wheel Trailer so it Rides Level
- Article: Trailer Tire Sizing
- Article: Double-Eye Trailer Suspension System Review
- Q&A: Can 3,500 lb Axle Trailer Leaf Spring 25-1/4 inch get Replaced with 5k Rated Spring
- Q&A: Recommended Suspension Enhancements for a 2022 Grand Design Imagine 2910BH
- Article: Slipper Spring Trailer Suspension System Review
- Article: Most Popular Wheel Bearings
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Is it Possible to Raise Suspension of Trailer that Has Slipper Springs
- Q&A: Installation of Dexter Kit # K71-385-00
- Q&A: Do Spring Seats Have to Be Welded to Install Axle Over Under Kit
- Q&A: Replacement Leaf Springs and Wet Bolt Kit For a 2007 Fleetwood Redline 33 Toyhauler