Middle Mounting Bracket to Top of Handle Distance for Bulldog Square Swivel Jack w/ Round Pipe Mount
Question:
what is the distance between the center of the mounting pin and the top of the handle?
asked by: Mike L
0
Expert Reply:
The distance from the middle of the mounting bracket to the top of the handle measures 10-3/4" for the Bulldog Square Swivel Jack w/ Round Pipe Mount # BD195306.
Attached is a dimensional photo for you to check out!
expert reply by:
Jon G
0
Product Page this Question was Asked From
Bulldog Square Swivel Jack w/ Round Pipe Mount - Topwind - 15" Lift - 3,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 2001 - 3000 lbs
- Swivel Jack
- Topwind Jack
- 15 Inch Lift
- Pipe Mount
- Weld-On
- With Rectangle Foot
- Bulldog
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Would Ark Stabilizers Be Better Than Scissor Jacks With JT Strong Arm Stabilizers
- Q&A: Trailer Hitch For 2016 Subaru Outback That Won't Interfere With Rear Shocks
- Q&A: How to Measure the Angle of Trailer A Frame To Determine if a 50 Degree A Frame Coupler will Fit
- Q&A: What are the Measurements on a Bulldog Square Swivel Jack # BD190758
- Q&A: 2024 Subaru Outback Wagon Trailer Hitch Recommendation
- Q&A: Replacing Foam Bumper When Installing Curt Receiver #13410 On a 2019 Subaru Outback
- Q&A: Reinstalling the Bumper on 2017 Subaru Outback With Hidden Trailer Hitch
- Article: Replacement Automotive Lighting
- Article: My Trailer Hitch Doesn't Fit
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Trailer Jacks
- Article: Testing Brake Controls