Can A Trailer Hitch Be Installed On A 2014 Toyota Tundra With A TRD Rear Anti-Sway Bar
Question:
Will the Curt Class V #C15398 work on second gen Tundras with factory installed TRD Sway Bar?
asked by: Benny M
Expert Reply:
The PTR11-34070 (sway bar) uses the same bolt hole as a trailer hitch would but in the installation instructions it lists that it uses different spacers depending on if you have a trailer hitch installed or not. It lists that you'll need to replace the current bolt with an M14x1.5x120 (22mm) bolt and install the end link hardware in the following order: 22mm bolt, washer #1, end link, washer #2 & spacer.
Based on this information you will be able to install the Curt Trailer Hitch Receiver # C15398, but may need to get additional hardware to reinstall the sway bar after installing the hitch.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class V - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class V
- 2400 lbs TW
- 16000 lbs GTW
- 17000 lbs WD GTW
- 2 Inch Hitch
- 2400 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Does the Curt Hitch C15398 Support the Bumper on a 2013 Toyota Tundra?
- Q&A: Recommended Hitch for a 2008 Toyota Tundra
- Q&A: Replacing Factory Hitch on 2006 Toyota Tundra
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Can an Aftermarket Trailer Hitch be Installed on a 2017 Toyota Tundra with Factory Trailer Hitch
- Q&A: 2021 Toyota Tundra Trailer Hitch Receiver Recommendation
- Q&A: Recommended Hitch for a 2024 Jeep Grand Cherokee L
- Q&A: Is there a Hitch for the 2013 Toyota Tundra's that Have a Factory Hitch?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Pintle-Hitches
- Article: How to Choose a Battery Charger
- Article: Trailer Lighting Requirements