Can a Manual Raise/Lower Trailer Jack Be Converted to Be Used With a Drill
Question:
I have a square tube side wind jack on my car hauler. Is there a replacement crank pin that converts the jack to use with a drill?
asked by: Mike V
Expert Reply:
The only jack that can be converted to be used with a drill would be the Bulldog single speed jacks with a 12K capacity. If you have this jack then you'd just need the conversion kit # BD1824200100 and the gear kit # BD500212.
Otherwise, you'd need to just replace the jack with one that can be used with a drill like the Trailer Valet JXC Trailer Jack w/ Footplate and Drill Powered Option # TV94FR.
Products Referenced in This Question
Bulldog Powered-Drive Kit for Single-Speed Jacks w/ 12,000-lb Capacity
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Powered-Drive Kit
- Bulldog
more information >
Replacement Gear Kit for Bulldog Sidewind Jacks w/ 12,000-lb Capacity
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Gears
- Bulldog
more information >
Trailer Valet JXC Trailer Jack w/ Footplate and Drill Powered Option - A-Frame - Sidewind - 5K
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jack
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Drill Powered
- Sidewind Jack
- 14 Inch Lift
- Bolt-On
- With Rectangle Foot
- Trailer Valet
more information >
Product Page this Question was Asked From
Replacement Handle Shaft for etrailer and Ram Square, Direct Weld Jacks - 10,000 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Handles and Cranks
- Handle Rod
- etrailer
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Hard Tonneau Covers vs Soft Tonneau Covers
- Q&A: Does the Galeo Ride GPS Tracking Device for Bikes Come with Everything Needed
- Q&A: Replacement Brass Bushing and Rod for 12,000 lb Fulton Jack
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Q&A: Big Tex Trailer Ramp Replacement Springs
- Q&A: Pairing Instructions for the Galeo Ride GPS Tracking Device for Bikes
- Q&A: Replacement Parts for the Square Direct Weld Jacks
- Q&A: Do 8k Oil Bath End Caps On Lippert Axle Interchange With Dexter End Caps
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Parts for Bulldog Square Jack
- Article: How to Measure for Trailer Hitch Drop
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How to Wire an Electric Winch
- Article: Trailer Lighting Requirements