What Mounting Hardware Is Needed For Installing Black Bracket and Single Wire Plug # A65PB?
Question:
how does the backet for part @ A65pB get attached to the trailer?
asked by: Stacey S
0
Expert Reply:
The Black Bracket and Single Wire Plug # A65PB will attach to your trailer either using self-tapping screws or nuts and bolts. The type and length of the parts will also depend on the surface you are attaching to on your trailer. The 3/16" diameter mounting holes are 3" on center if you are replacing any current lights you may have.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Black Bracket and Single Wire Plug for Thin Line Series Trailer Clearance and Side Marker Lights
- Accessories and Parts
- Trailer Lights
- Mounting Hardware
- Brackets
- Black
- Optronics
more information >
Continue Researching
- Q&A: Replacement 5 Leaf Slipper Spring for a Tandem Axle Dump Trailer with Two 6K Axles
- Q&A: Installation Information for the Replacement Cables for Enclosed Trailer Ramp Spring # ERS160D96
- Q&A: Can Hydraulic Brakes of Demco Tow Dolly be Converted to Electric Brakes
- Article: Trailer Wiring Diagrams
- Article: What To Look For When Buying Ratchet Straps
- Q&A: Replacement Roof Vent Cover for Lid Marked AS-13M-VDO449 ANS Z26 1
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: What Type Of Hydraulic Fluid Should I USe With A Lippert Hydraulic Leveling System?
- Q&A: Finding A Replacement Electric Winch For 2007 Rockwood Popup Camper
- Q&A: Troubleshooting A Clunking Noise Between A Fifth Wheel Hitch And Base Rails While Towing
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Trailer Maintenance Schedule
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Most Popular Wheel Bearings