What Size is The Hardware For The Yakima Load Stops # Y01161 To Fit Inside The Channel?

Question

Question:

Hey I am interested in purchasing a product you guys carry but I want to confirm a measurement before buying to see if it’ll fit my bed rack. The load stop you guys carry is the t slot nut 3/4” or less ?

asked by: Marlon B

0

Expert Reply:

The T-Slot Mounting Hardware # Y38FR for the Yakima Load Stops # Y01161 is right at 3/4" wide.

expert reply by: Bud M

0

Answer 1

We do offer one of those parts, which are the replacement end caps for your crossbars (which you mentioned were Streamline though I believe you were referring to the JetStream). What you need for those is the Replacement Endcaps for Yakima JetStream…

view full answer...

Answer 2

It looks like you have the Thule Aeroblade bar. The T-slot dimensions are 1/2 inch wide for the top of the opening and 3/4 inch wide at the bottom. The T-slot is 1/8" inch tall.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 5

For a roof rack to be compatible on your 2020 Jeep Wrangler with Sky One-Touch Power Top, it can't be mounted on the top of the roof and it needs to be high enough for the folding roof to clear. What you need are tall gutter-mounted roof racks.…

view full answer...

Answer 6

Hey Jeremy, Typically with boat trailers the manufacturer will install hydraulic surge brakes because you don't have to worry about the water damaging wires like you would with electric brakes. That being said, if you use a heat shrink butt…

view full answer...

Answer 7

Thanks for all the details! We definitely have a way to get a cargo basket and an awning installed on your 2024 Toyota Highlander, although the aftermarket roof rack systems will use a clamping system with your door jambs instead of mounting via…

view full answer...

Answer 8

Yakima's Skyline towers part #Y53TR can fit the tracks of the Retrax XR that you have with the landing pad 1 part #Y00221 but there isn't a way with the Baseline towers. Your Yakima Corebar or Jetstream bars will work with the Skyline towers…

view full answer...

Answer 9

According to Rhino Rack, if you were to go with the shorter bars, you'll only have 1-1/4 inch of leeway on each side which isn't enough in their opinion. I'd recommend going with the 71 inch bars so you'll be certain of a good fit. As…

view full answer...

What Size is The Hardware For The Yakima Load Stops # Y01161 To Fit Inside The Channel?

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching