Wire Gauge Required for Redarc 60-Amp Relay Kit
Question:
60-Amp Relay Kit for Redarc In-Vehicle BCDC Battery Charger Do you know wire size is used with this kits pigtails? Mainly concerned with feed wires on post 30 and 87. Thank you.
asked by: Jeff K
0
Expert Reply:
According to the instructions for the 60-Amp Relay Kit # 331-RK1260, the power wires need to be at least 6mm (squared) which is the equivalent to 10 Gauge Wire # 10-1-1.
expert reply by:
Jon G
0
Wiring Diagram for 60-Amp Redarc Relay Kit
(click to enlarge)
(click to enlarge)
Products Referenced in This Question
Product Page this Question was Asked From
60-Amp Relay Kit for Redarc In-Vehicle BCDC Battery Charger
- Accessories and Parts
- Trailer Brake Controller
- Relays
- Redarc
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Will a Leveling Kit on a 2016 Ford F-150 Affect the RoadActive Suspension Kit?
- Q&A: Can The RAS And SumoSprings Be Installed At The Same Time?
- Q&A: 7-Way Trailer Wiring Setup Recommendation for a Tandem Axle Trailer
- Q&A: Is Relay Kit Needed for BCDC Installation if Ignition is Already Ran to BCDC on Trailer
- Q&A: Replacing 6-Way on Trailer With 7-Way Connector
- Q&A: Can Different Brand Trailer Bearings Be Used As Replacements
- Q&A: Replacement Bearing and Seal Kit for Dexter 6k Trailer Axle
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: How to Charge a Dump Trailer Battery
- Article: Brake Controller Installation: Starting from Scratch
- Article: How Many Batteries Do You Need to Run RV Air Conditioner?
- Article: How Much Solar Power Do I Need For My RV?