Where do Red and White Wires Go On Progressive Dynamics Converter Replace # PD4645V
Question:
i bought a replacement power comverter with battery charger for a Magnetex series 6300A model 6345. With the wiring where does the I believe number 6 red and white wires go on the new board?
asked by: Michael T
1
Helpful Expert Reply:
The red wire should go to the terminal labelled +VCC and the white should go to the terminal labelled NEG- on the DC panel of the part # PD4645V.
I attached a link to the install instructions for this on this page for you to check out as well.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Progressive Dynamics Replacement Section for AC/DC Power Distribution Panel - 45 Amp
- Accessories and Parts
- RV Converters
- Converter Section
- 45 Amp
- Progressive Dynamics
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: What Replacement Converter Do I Need for a Series 7300 Model 7345 Converter?
- Q&A: Replacement RV Power Converter for Parallax 7345
- Q&A: Replacement Converter for Magnetex B-W Manufacturers 6300A Model 6345
- Q&A: Direct Replacement Converter for Parallax/Magnetek 6345 RV Power Converter
- Q&A: Replacement Converter for 45 Amp Magnetek 6345
- Q&A: What Replacement Converter Do I Need for a Series 7300 Model 7345 Converter?
- Q&A: Magnetek Series 6300A Model 6332 Replacement Converter
- Article: How to Repair an RV Roof
- Article: Top 10 Upgrades for Your Camper
- Article: How Much Solar Power Do I Need For My RV?
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: 4-Step Guide to Installing RV Solar Power