Can Utility Trailer Hubs Be Changed From A 5 On 4.5 Bolt Pattern To A 6 On 5.5 Bolt Pattern
Question:
Good morning, I have a small utility trailer with a 5 x 4.5 bolt pattern on 10 brake drums. Id like to change the bolt pattern to a 6 x 5.5 bolt pattern to match my Toyota Tacoma. This is a kit built trailer and I do not know the axle specifics. Can you recommend a product?
asked by: Josh
Expert Reply:
To swap out your hub/drum assemblies to a 6 on 5.5 bolt pattern you'll need to measure the axle spindle at points B, C, and D with a set of calipers # PTW80157 so that we can see which assembly has a matching bearing and grease seal. If your axle has no capacity listed on it then you'll also want to measure the diameter of the axle tube so we can try to determine the capacity using the spindle measurements as well.
For example, if point C measured 1.378", point D measured 1.063", point B measured 1.719", and the axle tube measured 2-3/8" in diameter then you could replace your hub/drum assemblies with part # AKHD-655-35-EZ-K.
Products Referenced in This Question
4" Carbon Fiber Digital Caliper
- Hand Tools
- Measuring and Layout Tools
- Digital Calipers
- Carbon Fiber
- Performance Tool
more information >
Product Page this Question was Asked From
Easy Grease Trailer Hub and Drum Assembly for 3.5K Axles - 10" - 6 on 5-1/2 - Pre-Greased
- Trailer Hubs and Drums
- Hub with Integrated Drum
- Easy Grease
- EZ Lube
- Pre-Greased
- L68149
- L44649
- For 3500 lbs Axles
- 1/2 Inch Stud
- 6 on 5-1/2 Inch
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- 16 Inch Wheel
- 16-1/2 Inch Wheel
- etrailer
more information >
Continue Researching
- Q&A: Replacement 3500 lb Hub/Drum for TruRyde RVD-H-65535 10 Inch Trailer Brake Drum
- Q&A: Replacement For A Truryde RVD-H-65535 Hub
- Article: Most Popular Wheel Bearings
- Q&A: Replacement Hub and Drum Assembly for Lippert 4.4K 136214 Hub and Drum
- Article: Trailer Tire Sizing
- Q&A: Parts Needed to Replace 12" Disc Brakes with Electric Drum Brakes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Maintenance Schedule
- Q&A: Replacement Brake Assembly for Axletek 44-GG
- Article: Trailer Wiring Diagrams
- Q&A: 6k Hub Drum that Can Fit Timbren Axle Less Kit part # ASR1THDS03
- Q&A: Can I Install Brakes On Only One Axle Of A 2 Axle Trailer And Which Axle Should They Go On?
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer