Troubleshooting Lippert Ground Control 3.0 Rear Legs That Stall During Auto-Leveling Process

Question

Question:

When I auto level rear jacks start to come down. Then one will stall sometimes left sometimes right. Once the the extending jack takes to much I get auto level fail.

asked by: Jerry M

1

Helpful Expert Reply:

I've dealt with this with my dad's 5th wheel off and on and it usually comes down to power. The Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System # LC675817 requires 12.75 volts to properly operate. Anything less and you'll start having issues. If you plug into shore power and then try using the auto level feature does it give you any issues?

You can also check the wiring running from the control module # LC85ED to the legs to see if there's any damage or loose connections that could be causing the issue.

expert reply by: Kevin C

1

Answer 1

Yes, the Go Power Industrial Pure Sine Wave Inverter Charger #34280055 that you referenced is compatible with lithium LifePo4 batteries like the part #34282740 that you also referenced.

view full answer...

Answer 2

After a bit of cross referencing I found that you have the Kwikee 32 series steps, and they were manufactured in 2005, so the correct motor is the Replacement Motor for Kwikee Electric RV Steps #LC379147. If you are needing more than the motor, the…

view full answer...

Answer 3

Hey David, from previous customers of ours who have the same 2020 Keystone Raptor 424 we have determined that your pin box style is the Lippert 1621 which means for a Gen-Y gooseneck adapter you'd want the #GY58GR that you referenced.

view full answer...

Answer 4

Hey Cory, thanks for reaching out! The Replacement Support Leg #TH33VK is for the 8-1/2" long Thule HideAway awnings which is what I believe will be a better match than the part #TH48VK you referenced, which is for a 10' long HideAway…

view full answer...

Answer 5

Hey Steven, the Go Power Solar Panel kit part #GP66FR that you referenced does come with the correct 2-pin XLR style of plug that your Furrion solar charge input uses so it will work fine without needing an adapter. This comes with a few connector…

view full answer...

Answer 6

We have just what you need, the Go Power Portable Solar Panel with Digital Solar Controller, #34282610. This lets you place the solar panel where you need it for maximum sunlight while not having to place the camper in the sun too. For the later…

view full answer...

Answer 7

I recommend using the Go Power Industrial Pure Sine Wave Inverter Charger #34275013. This will reduce all the components into one system by combining your transfer switch inverter and converter/charger into one unit. You will be able to wire in your…

view full answer...

Answer 8

The difference between the 1621 and the 1621SHD is weight capacity and how many bolts is required to mount it. The 1621 uses 4 bolts for mounting. The 1621SHD requires all 6 bolts to be used.

view full answer...

Answer 9

The 12v accessory pin from the 7-way would need to be connected to the battery in order to charge it so you'd first need to make sure it was actually wired that way since not every manufacturer does. That being said the trickle charge coming from…

view full answer...