How Do The Pointy Ends Of The Solera Awnbrella Support Kit # LC362237 Attach to Awning?
Question:
where does the pointy end go???
asked by: Kent E
0
Expert Reply:
The pointy ends of the Solera Awnbrella Support Kit # LC362237 go into the awning tube. I have linked the installation instructions below which detail where to drill additional holes in your awning tube for these supports to insert into.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Solera Awnbrella Support Kit for 14' to 18' Wide RV Awnings w/ 8' Projections
- Accessories and Parts
- RV Awnings
- Support
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Solera Awnbrella Support Kit for 14' to 18' Wide RV Awnings w/ 8' Projections
- Shop: Solera Family Room for 16' Wide RV Awnings - Gray
- Shop: Solera RV Slide-Out Awning - 169" Wide - White
- Search Results: locking battery box
- Q&A: Replacement Awning Motor Options for a Lippert Solera Awning W/ A Venture Motor
- Q&A: Replacement Motor for a Lippert Edge Awning and How to Replace It
- Q&A: Replacement Motor for Solera Power Awning of RV
- Q&A: Compatibility of Replacement Motor for Lippert Solera Power Awnings
- Q&A: Options to Help Reduce Noise From an Awning with Solera Smart Arms Flapping in the Wind at Night
- Q&A: Solera 63 Replacement Short Arm Assembly for Awning
- Q&A: Options to Vent a Storage Compartment on an RV
- Article: 7 Steps to Clean Your RV Awning, Prevent Mold, and Save Money
- Article: How to Replace an RV Roof Vent Cover
- Article: Calculating Portable Generator Power Needs
- Article: What is Overlanding? How to Start your Overlanding Journey
- Article: How to Measure for Motorhome Steps
- Article: How to Install an RV Awning From Scratch
- Article: How to Drain an RV Water Heater