Troubleshooting Curt Trailer Wiring Harness Functions Not All Working
Question:
2000 Ford ranger part # 55344. Have no power to the trailer, trailer works plugged in to other vehicles. brown wire is the one no that has no power to it, but all my lights work on my truck.
asked by: Jordan
0
Expert Reply:
Make sure all of the pins of the Curt trailer wiring harness part # C55344 are clean as that's typically what causes this problem. Other issue could be that the connectors are not seated all the way. To fix that you'd just need to disconnect and reconnect all of the connectors and that should take care of the problem.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Can I Use A Tow Bar With The 2" Hitch On A 2006 Ford E350 Van?
- Q&A: Trailer Hitch for 2014 Ford E-350 Cutaway Chassis
- Article: RV-Mounted vs Vehicle-Mounted Tow Bars
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Hitch for a 2001 Ford E-350 Ecoline Van
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Performance Chips and Modules
- Q&A: Master Cylinder Brake Line Fitting for Titan Model 60 Disc Brake Actuator
- Q&A: How Does a Trailer Hitch Install on a 2003 Ford ZX2
- Q&A: Trailer Hitch and Wiring for a 1999 Ford Escort ZX2
- Q&A: Everything Needed for a 1994 Ford Escort to Tow a Small Trailer
- Article: Routing the Power Wire for a Trailer Wiring Harness