Trailer Wheel Stud with Knurled Section Close to .53 inch
Question:
Good Morning, I have a trailer with some older hubs. The wheel studs have a collar that presses in to the hub with a measurement of .530inch OD. Are there wheel studs available to replace these? Thank you
asked by: Randy A
0
Expert Reply:
We have the Kodiak wheel stud part # K12WB2 which is a 1/2 inch diameter wheel stud that has the press in section as .54 inches. This is closest option we have to what you need.
expert reply by:
Jameson C
0
Products Referenced in This Question
Kodiak Wheel Bolt - 1/2" Diameter x 2" Long
- Accessories and Parts
- Boat Trailer Wheels
- Trailer Hubs and Drums
- Trailer Tires and Wheels
- Wheel Studs
- 1/2 Inch Diameter
- Drive-In Stud
- 2 Inch Long
- Kodiak
more information >
Product Page this Question was Asked From
Timbren Axle-Less Trailer Suspension - Heavy Duty - Long Spindle w/ 4" Lift - 4 Bolt - 2.2K
- Trailer Axles
- Rubber Spring Suspension
- Easy Lube Spindles
- No Hubs
- 2200 lbs
- Spindles Only
- Universal Fit
- Lift - 4 Inch
- Timbren
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: 6k Hub Drum that Can Fit Timbren Axle Less Kit part # ASR1THDS03
- Q&A: Adding a Battery to a Trailer with a 4-Way Connector
- Q&A: Is There Trailer Axle Over Under Kit that Could Fit 5x8 Utility Trailer
- Q&A: Axel Flip Lowes 5 x 8 utility trailer
- Article: Trailer Tire Sizing
- Q&A: Availability Of 33" Ark Stabilizer Jack And Dimensional Diagrams Of Similar Ark Corner Steadies
- Q&A: Deflection of Timbren Axle-Less Trailer Suspension for Off-Road Tires ASR1THDS03
- Article: Trailer Lighting Requirements
- Q&A: Mounting Plate Dimensions for Ark XO Drop Down Corner RV Stabilizer Jacks
- Article: Where to Position the Trailer Axle?
- Article: How to Raise Your Travel Trailer Height
- Article: Determining Trailer Tongue Weight
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams