Troubleshooting A Namsco Wheel Cover That Seems Too Tight To Fit The Wheel
Question:
I’m having a very hard time getting these hubcaps installed. It seems like too tight of a fit with the retention rod. Do you have any suggestions
asked by: John J
0
Expert Reply:
The Namsco Wheel Covers # NA7160B0 doesn't have a retention rod, but instead has clips that latch onto the wheel so I'm wondering if you maybe got something else. I would double check the part number to verify that you have the correct one/size for your wheels and ensure that the cutout for the valve stem for the retention clips is placed over the valve stem when trying to pop the cover in place.
expert reply by:
Kevin C
0
NA7160B0 valve stem cutout
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Namsco Wheel Covers - 16", 8-Lug Wheels - 8 HH - Front/Rear
- Wheel Covers Hubcaps
- Wheel Covers
- Front and Rear Wheels
- 8 Hand Holes
- 8 Lugs
- 16 Inch Wheels
- Stainless Steel
- Namsco
more information >
Continue Researching
- Q&A: Will The Namsco Wheel Covers Fit A Chevy Workhorse With 16" Wheels
- Q&A: Wheel Cover Recommendation for a 2013 Ford E-350 Single Rear Wheel
- Q&A: Replacement Lug Nut Covers For 22.5 Alcoa Wheels
- Q&A: How to Install a Brake Controller on a 2018 Honda Pilot
- Q&A: Torque Spec for Tightening Replacement Brake Drum Mounting Bolt
- Q&A: Bolt Torque Value for Installing LC1387882 Lippert 1621 HD Replacement Pin Box
- Q&A: Replacement Fan Motor for Greystone RV Range Hood with Light 12V
- Article: How to Choose a Battery Charger
- Article: How to Replace an RV Roof Vent Cover
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them
- Article: Best Air Bag Suspension (2023)
- Article: The Basics: Firestone Air-Spring Kits
- Article: Frequently Asked Questions About Transmission Coolers