Determining The Correct Replacement Steps And Stabilizer Jacks For A 1998 Jayco Eagle 12UDK
Question:
Hello looking for some insights for 2 products for my 1998 Jayco eagle 12Udk. The first is an entry step. It has the 2 holes that go into the frame. Would like something that retracts and sturdy. The 2nd is a replacement stabilizer jack , which unfortunately ped down and fell out. Much appreciated.
asked by: Rob O
Expert Reply:
To replace the entry steps you'll need to measure the mounting bracket width and the entry height. I've attached an article below that will walk you through this process step by step. Once we know the entry height and bracket width we can pick out the correct steps. Pull out steps typically have a bit of give to them so you'll want to pick up a stabilizer like the Solid Stance # LC96BJ or go with TorkLift GlowSteps like part # TLA8102, which have landing gears.
As for the stabilizer jack, you'll just need to level your trailer and measure the distance from the ground to the frame to determine the correct height need for your trailer. The Stabilizer Jack # TJ01RT you were looking at adjusts from 11-1/2" to 18" in height.
Products Referenced in This Question
Lippert Solid Stance RV Step Support Kit
- Accessories and Parts
- RV Steps
- Stabilizers
- Lippert
more information >
TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear - 2 Steps - 25-1/2" Base - 375 lbs
- RV Steps
- Towable Camper
- Pull-Out Step
- 22 Inch Wide Step
- 25-1/2 Inch Wide
- 2 Steps
- 7-1/2 Inch Drop/Rise
- Ground Contact
- Aluminum
- TorkLift
more information >
Product Page this Question was Asked From
Stabilizer Jack - 6-1/4" Drop Leg Travel - 18" - 650 lbs - Qty 1
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- Stabilizer Jacks
- Steel
- 0 - 1000 lbs
- Drop Down Jack
- Bolt-On
- Weld-On
- 1 Jack
- etrailer
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Correct Replacement Parts for a Ventline VD0434 Roof Vent
- Q&A: Overall Dimensions Of The Stabilizer Jacks # TJ01RT-HD In The Stowed Position
- Q&A: Replacement AC Unit For The Carrier 68RV15102A
- Article: Trailer Lighting Requirements
- Article: Trailer Tire Sizing
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Comparing Kenda and Provider Trailer Tire in Size ST205/75R14
- Q&A: Comparing Kenda Karrier, Taskmaster and Provider Special Trailer Tires in Size ST21575R14
- Article: Most Popular Wheel Bearings
- Q&A: Load Capacity for Rackem Fitz-All Enclosed Trailer Ladder Rack
- Q&A: Can I Replace Leaf Springs With Lower Rating For Better Ride Quality