Should The Ground Control 3.0 Be Wired Directly To The Battery Or Battery Disconnect Switch
Question:
I had my ground control installed by a local trailer shop. They have my system wired directly to the battery bypassing the battery switch. Is this correct?
asked by: Steve B
0
Expert Reply:
The Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System # LC675817 can be wired directly to the battery or to a battery disconnect switch depending on your personal preference. Personally, I would wire it to the disconnect switch so that it isn't sitting there draining the battery while in storage.
expert reply by:
Kevin C
0
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 6-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 6 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Which Lippert Ground Control 3.0 System Is Recommended for a 37' Fifth Wheel
- Q&A: Hole To Hole Dimensions For Replacement I-Beam Jack Bracket # LC349975
- Q&A: Solutions To Add More Clearance For Lippert Ground Control 3.0 Jack Legs
- Q&A: Is The Pad For The Replacement 22-1/2" Legs For The Ground Control 3.0 Welded Or Pinned In Place
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Wiring Diagram and Fuse Location for the Lippert Ground Control 3.0 4-Point Leveling System
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: Wiring Installation for 5th Wheel Landing Gear Switch
- Q&A: Wiring Guide for Installing 5th Wheel Landing Gear Motor Switch
- Article: The Best 5th Wheel Hitches
- Article: No Missteps Here: Best Camper and RV Steps (2022)
- Article: Best 2020 Heavy Duty Trucks for Towing a 5th Wheel
- Article: Trailer Maintenance Schedule
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs