Recommended Flat Towing Parts for a 2010 Ford Ranger 4WD
Question:
I would like to flat tow a 2010 Ford Ranger 4x4 automatic have been told its possible with installation of a flat tow kit. Ford no longer makes these is this something you can help with? Thanks
asked by: Phil G
Helpful Expert Reply:
It is absolutely possible and I'd be happy to help. In order to flat tow your 2010 Ford Ranger 4WD behind your 2013 Coachman Encounter you are going to need a high low adapter, tow bar and safety cables, base plate kit, wiring harness, and a supplemental braking system. The braking system is required by law in most states and Canada no matter how big your motorhome is.
To flat tow your 2010 Ford Ranger 4WD you will need the following parts:
Tow Bar and Safety Chains - Roadmaster Falcon 2 Tow Bar item # RM-520 and item # RM-643
Crossbar Assembly - Crossbar Assembly for Roadmaster Tow Bars item # 910021-00
Base Plate Kit - Roadmaster Crossbar-Style Base Plate Kit - Removable Arms item # 477-1
Wiring Harness - Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit item # RM-15267
Supplemental Braking System - Brake Buddy Select 3 Portable Supplemental Braking System item # HM39524
High Low Adapter - The tow bar needs to be within 3" of level. If you measure the height of the inside top of the hitch receiver tube on your RV, and the height difference is more than 3 inches above/below the base plate tab height, you'll need a high/low adapter. I have linked a FAQ article that explains all this in more detail along with our selection of adapters.
Products Referenced in This Question
Roadmaster Crossbar-Style Base Plate Kit - Removable Arms
- Base Plates
- Removable Drawbars
- Hitch Pin Attachment
- Roadmaster
more information >
Replacement Quick Disconnect Crossbar Assembly for Roadmaster Tow Bars
- Accessories and Parts
- Tow Bar
- Quick Disconnects
- Car Side and Tow Bar Side
- Roadmaster
more information >
Brake Buddy Select 3 Portable Flat Tow Brake System - Proportional
- Tow Bar Braking Systems
- Brake Systems
- Proportional System
- Recurring Set-Up
- Portable System
- Air Brakes
- Air Over Hydraulic Brakes
- Hydraulic Brakes
- Brake Buddy
more information >
Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit
- Tow Bar Wiring
- Splices into Vehicle Wiring
- Diode Kit
- Universal
- Tail Light Mount
- Roadmaster
more information >
RoadMaster 68" Single Hook, Coiled Safety Cables - 6,000 lbs
- Safety Cables
- Coiled Cables
- 68 Inch Long
- 6000 lbs GTW
- Snap Hooks
- Coated Cables
- Roadmaster
more information >
Product Page this Question was Asked From
Roadmaster Falcon 2 Tow Bar - RV Mount - 2" Hitch - 6,000 lbs
- Tow Bar
- Hitch Mount Style
- Telescoping
- Steel
- 6000 lbs
- Fits Roadmaster Base Plates - Crossbar
- Fits Roadmaster Base Plates - Direct Connect
- Stores on RV
- Standard
- Roadmaster
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Trailer Wiring Diagrams
- Article: Must-Have Flat Towing Components
- Q&A: 2024 Ford Maverick Wiring Needed for Flat Towing Behind a Motorhome
- Q&A: Does The Demco Baseplate # DM77YV Require That You Trim The Air Shutters/Dam On A Ford Maverick
- Article: How to Choose a High-Low Adapter
- Q&A: How Can I Adapt The SD Non-Binding Tow Bar e34ZR To D-Rings On A Jeep Bumper?
- Q&A: Availability of InvisiBrake Installation Video on 1998 Jeep Wrangler
- Q&A: Parts Needed to Flat Tow 2024 Jeep Wrangler 4xe
- Q&A: Recommended Flat Towing Parts for a 2023 Ford Bronco Badlands w/ a Capable Bumper
- Q&A: Included in Package of Roadmaster Falcon 2 Tow Bar
- Article: How Level Should a Tow Bar Be When Flat Towing
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)