Parts Needed To Properly Transfer Light Signals From A Honda Goldwing To A Motorcycle Trailer
Question:
I have a 2022 goldwing with a 5 flat connector. My motorcycle trailer has a 4 flat. Can they be connected? The bike is splitting the brake and tail lights. The trailer has them combined. Help
asked by: Gene
Expert Reply:
While there currently isn't an adapter to easily go from the 4-pole connector on your trailer to the 5-pole connector on your Goldwing I do still have a solution for you. You'll need to cut off the 4-pole connector on the trailer and splice in a 5-pole connector like part # HM37918. You can just cap off the reverse light wire with some electrical tape and if you ever wanted to install reverse lights on the trailer you could then run a line off it it. I recommend using some heat shrink butt connectors # DW05744-10 for a waterproof connection.
If your Goldwing has separate tail light circuits and the trailer has combined tail light circuits then you will need part # RM-732 as well. If the motorcycle has combined tail light circuits and the trailer has separate tail light circuits then you will need a 2-to-3 converter like part # C56196.
This should allow you to connect your trailer to the motorcycle and fix any signal issues you might be facing.
Products Referenced in This Question
Curt 2 to 3 Wire Tail Light Converter
- Tow Bar Wiring
- Splices into Vehicle Wiring
- Tail Light Converter
- Universal
- CURT
more information >
Deka Heat Shrink Butt Connector - 16-14 Gauge - Nylon Insulation - Blue - Qty 10
- Wiring
- Wire Connectors
- Butt Connectors
- 16-14 Gauge
- Deka
more information >
Hopkins Wiring Harness with 5-Pole Flat Trailer Connector - Trailer End - 18" Long
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 0 - 5 Feet Long
- Plug and Lead
- 5 Flat
- Hopkins
more information >
Roadmaster Brite-Lite Wiring Converter
- Tow Bar Wiring
- Splices into Vehicle Wiring
- Tail Light Converter
- Universal
- Roadmaster
more information >
Product Page this Question was Asked From
Tow Ready 4 Pole to 5 Pole Trailer Wiring Adapter
- Trailer Wiring
- Wiring Adapters
- Single-Function Adapter
- 0 - 5 Feet Long
- 4 Flat
- Plug and Lead
- 5 Flat
- Tow Ready
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Can a 4-Way Trailer Connector be Plugged Into a 5-Way Vehicle End Trailer Connector
- Q&A: Best 4-Way Trailer Wiring Harness For 2024 Toyota RAV4
- Article: Trailer Tire Sizing
- Q&A: Parts Needed to Install 5-Way on 2019 Toyota RAV4
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Recommended Trailer Hitch for a 2024 Toyota RAV4
- Article: Trailer Maintenance Schedule
- Q&A: What Colors are Trailer Brake Magnets Wires
- Q&A: When Using a 5-Way for Tow Bar Wiring Which Pin for a Charge Line Kit
- Q&A: Seal With Dimensions to Replace 171255UC
- Article: How to Choose the Right Trailer Hitch Class