Lift Kit For Crossroads 5th Wheel
Question:
I need to lift my fifth wheel 3”-4”. 2019 crossroads volante 27’ BH Tandem axles. Bottom mount hangers are 3” wide with leaf springs width of1-3/4”. Do you make a kit to do this without cutting the existing hangers off the frame? Thanks
asked by: Stephen C
Expert Reply:
We don't make lift kits just sell them but the only way to get a lift that high is with an over/under kit which moves your trailer's leaf springs to the top of your axle and lifts your trailer approximately the same amount as your axle's diameter plus the height of the leaf spring pack. The right one will depend on what size your axle is:
- 2-3/8" Round Axle: Dexter Trailer Springs Over-Under Conversion Kit # K71-384-00
- 3" Round Axle: Dexter Trailer Springs Over-Under Conversion Kit # K71-385-00
A 2-3/8" axle is generally a 3,500 lb axle while a 3" is generally a 5,200 - 7,000 lb axle. If your leaf springs are already above your axle the max lift available is 2-1/4" with the Correct Track Trailer Alignment and Lift Kit - Tandem Axle # RR23QX.
Otherwise you'd need to cut your hangers off and get taller ones, with our tallest being the Front/Center/Rear Hanger for Double-Eye Springs - 4-1/4" Tall # E4139.
Products Referenced in This Question
Front/Center/Rear Hanger for Double-Eye Springs - 4-1/4" Tall - 9/16" Bolt Hole
- Trailer Suspension Parts
- Hangers
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- 9/16 Inch Diameter
- 4-1/4 Inch Tall
- Single Axle
- Tandem Axle
- Triple Axle
- Redline
more information >
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 2-3/8 Inch
- Single Axle
- Dexter
more information >
Correct Track Trailer Alignment and Lift Kit - Tandem Axle
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Slipper Springs - 2 Inch
- Tandem Axle
- RV Ride Control
more information >
Product Page this Question was Asked From
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 3 Inch
- Dexter
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Raise Your Travel Trailer Height
- Q&A: How to Raise a 5th Wheel Trailer so it Rides Level
- Article: Trailer Tire Sizing
- Article: Double-Eye Trailer Suspension System Review
- Q&A: Recommended Suspension Enhancements for a 2022 Grand Design Imagine 2910BH
- Article: Slipper Spring Trailer Suspension System Review
- Article: Most Popular Wheel Bearings
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Is it Possible to Raise Suspension of Trailer that Has Slipper Springs
- Q&A: Installation of Dexter Kit # K71-385-00
- Q&A: Do Spring Seats Have to Be Welded to Install Axle Over Under Kit
- Q&A: Replacement Leaf Springs and Wet Bolt Kit For a 2007 Fleetwood Redline 33 Toyhauler
- Q&A: Replacement Leaf Springs For a 2007 Feetwood Redline 33 Toy Hauler Travel Trailer