Replacement Brakes and Bearings for 2000 Fleetwood Terry Travel Trailer
Question:
Looking for 4 sets of complete brake parts and wheel bearings for 2000 Fleetwood Terry trailer. 10x1.5
asked by: Philip R
Expert Reply:
It sounds like you need 10" x 1-1/2" brake assemblies. The only replacement option is the Dexter Electric Trailer Brake Kit # K23-472-473-00. Assuming you have 3,000 lb axles, more than likely the inner bearing is # LM67048 and the outer bearing is # L44649. The correct grease seal would be the # RG06-050 (10-19). I recommend verifying this information to be sure.
Products Referenced in This Question
Replacement Trailer Hub Bearing - L44649
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.063 Inch I.D.
- Bearing L44649
- Race L44610
- 3500 lbs Axle
- etrailer
more information >
Replacement Trailer Hub Bearing - LM67048
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.250 Inch I.D.
- Bearing LM67048
- Race LM67010
- 5000 lbs Axle
- 6000 lbs Axle
- etrailer
more information >
Grease Seal - Double Lip - ID 1.719" / OD 2.565" - for 3,500-lb Axles - Qty 2
- Trailer Bearings Races Seals Caps
- Seals
- Grease Seals - Double Lip
- 1.719 Inch I.D.
- 2.565 Inch O.D.
- etrailer
more information >
Product Page this Question was Asked From
Dexter Electric Trailer Brakes - 10" - Left/Right Hand Assemblies - 3,000 lbs
- Trailer Brakes
- Electric Drum Brakes
- Standard Grade
- Manual Adjust
- 10 x 1-1/2 Inch Drum
- 3000 lbs Axle
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- Dexter
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Most Popular Wheel Bearings
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: How to Measure to Determine the Size Trailer Brakes Needed For Hydraulic Drum Replacement
- Q&A: How Thick Are Electric Brake Shoe Pads and When Should They be Replaced
- Q&A: Correct Replacement for 10 Inch x 1-3/4 Inch Braking Assemblies
- Q&A: Why Would Trailer Brakes Get Warmer on One Side When Brake Controller is Used
- Q&A: Need a Chrome 1/2"-20 Lug Nut to Be Removed with a 3/4" Socket
- Q&A: Replacement Hubs/Drums and Braking Assemblies for a Vintage Stidham Horse Trailer
- Q&A: How To Measure a Trailer Hub/Drum for Replacement