What Color Wires Circuits are On Optronics LED Light # STL90RB
Question:
Hello on this STL90RP so it has the three wires. White is ground. Do you hook the signal wire up with the running light wire? I loved this video but would like to see how to hook 4 wires to the 3 wires.
asked by: Troy R
0
Expert Reply:
On the Optronics light # STL90RB the black wire is for the stop/turn circuit so that is where you'd run your blinker circuit to. The black wire gets the running light circuit and white is ground.
You would need to identify all 4 of your wires to determine how to run them to the light. It's very possible that two of the wires are grounds.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Optronics LED Transit Tail Light - Stop, Tail, Turn - Submersible - 31 Diodes - Red Lens
- Trailer Lights
- Tail Lights
- Stop/Turn/Tail
- Round
- Surface Mount
- Submersible Lights
- LED Light
- 7 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Shop: Optronics LED Transit Tail Light - Stop, Tail, Turn - Submersible - 31 Diodes - Red Lens
- Q&A: Replacement Motor for Klauber Slide Out Motor K01431B300
- Q&A: Can I Use the Die-Cast Grate for Furrion Range on a Dometic CU-423 Range
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Replacement for Dexter Hub 008-249-07 and Replacement Electric Brakes
- Q&A: Circuit Board Replacement for MaxxFan 4751KS
- Q&A: Installing a Brake Controller on a 2007 Chevy Express Van with Factory 7-Way Trailer Connector
- Q&A: Selecting Replacement Trailer Wheel for 1957 Airstream Trailer
- Q&A: Retracted Height Dimension of the Bulldog Jack part # BD190708
- Article: Trailer Wiring Diagrams
- Article: How Much Solar Power Do I Need For My RV?
- Article: How to Rent an RV
- Article: 4 Reasons Not to Use RV Solar Power (And 4 Reasons You Should)
- Article: Most Popular Wheel Bearings