Is Optronics Low Profile LED Flood Light Dimmable

Question

Question:

Is the Optronics Thinline LED Utility Light - Submersible - 386 Lumens - Clear Lens - 12-5/8 Long Item # UCL59CB dimmable?

asked by: Steve

1

Helpful Expert Reply:

The Low Profile LED Flood Light # OPT64FR only works at a set brightness which is the same case for all of our floodlight-type lights. The only options we have that work with a dimmer switch are interior lights for RVs.

expert reply by: Jon G

1

Answer 1

I finally heard back from my rep at Optronics and I was told that the Low Profile LED Flood Light item #OPT64FR is dimmable if you hook it up to a dimmer like the LED Dimmer Rocker Switch item #37215225.

view full answer...

Answer 2

Hi there Matthew; appreciate that info and we do have the exact bearing kit you are looking for, with bearings BK2-100 and the 10-19 seal. What you need is the following: - Hub Bearing Kit #BK2-100

view full answer...

Answer 3

The Low Profile LED Flood Light #OPT64FR is rated IP X7. This means the device has level 7 water sealing, while its protection against dust is unknown.

view full answer...

Answer 4

Yes, for 5,200 standard trailer axles we have the hub part #8-219-4UC3-EZ which is a fit for 5,200 lb axles and has the bolt pattern of 8 on 6-1/2 inches like you said you need.

view full answer...

Answer 5

The AC distribution panel of the Progressive Dynamics 4100 Series RV Converter w/ Charge Wizard and AC/DC Distribution Panel #PD4135K is being grounded at the shore power connection point so you wouldn't need to ground it to the frame of the…

view full answer...

Answer 6

The Opti-Brite LED Work Light #TLL60FB is a 2-wire light with black being power and white being ground. It will wire in to your trailer's existing wiring. As long as the current lights run on 12, 24, or 36 volt DC this light is compatible.

view full answer...

Answer 7

We have seen people mount storage boxes on either side of the nose of a V-nose trailer like what you see in the picture I attached. The part #DZ91717P would work well if you have room for it like that. The dimensions of the box are 36"…

view full answer...

Answer 8

For the 13" #CE19503-2 there is a distance between the two outside mounting on center of 33-3/4 inches and 29-3/4 inches between the two inside holes. The holes on the mounting surfaces are spaced apart 5 inches vertically and 2 inches…

view full answer...

Answer 9

You are correct in your description of how to wire in a new auxiliary battery in your enclosed trailer. You will take the 7-Way's 12V power feed and route this to the positive terminal on the auxiliary battery, and you will ground the second…

view full answer...

Answer 10

So the right way for you to do this will depend on how often you're going to use the lights and how many of them there are. If a trailer isn't equipped with a battery, the interior lighting is frequently tied into the running lamp circuit.…

view full answer...

Answer 11

It sounds like you may have a 7-way trailer connector and a 4-way trailer connector on your truck and only a 4-way connector on your trailer. Is that correct? See the attached picture for examples of each. If this is the case, then this change will…

view full answer...

Answer 12

The best way to power the interior lights in your trailer is with its own independent battery. You will not want to use the breakaway battery. The breakaway battery is only designed to operate the breakaway and will drain extremely quickly,…

view full answer...

Is Optronics Low Profile LED Flood Light Dimmable

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching