Need Larger Diameter Replacement End Caps for Yakima Round Crossbars

Question

Question:

The end plugs are the wrong size, the outside circumference is perfect but the inside plug is way to small. My mistake. I did not realize there were different sizes.

asked by: Bengt K

0

Expert Reply:

We do indeed offer two sizes of replacement end caps for Yakima round crossbars.

We offer the smaller diameter # Y80159 that you referenced, and the larger diameter also in a set of four pieces as part # Y8007026. These larger diameter end caps fit all round Yakima crossbars except for the 86-inch size. This larger end cap is also offered in single units as part # Y8790009.

To give you some advance assurance that these larger caps will fit your crossbars I have pulled a set of part # Y8007026 from inventory and measured both its outer and inner diameters which are indicated on the attached photo that I have edited for you. The diameter of the inner portion (that fits inside the round crossbar tube) is 7/8-inch.

expert reply by: Adam R

0

click to enlarge

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Yakima's Skyline towers part #Y53TR can fit the tracks of the Retrax XR that you have with the landing pad 1 part #Y00221 but there isn't a way with the Baseline towers. Your Yakima Corebar or Jetstream bars will work with the Skyline towers…

view full answer...

Answer 5

Thanks for reaching out to verify, Frank! Yes, those parts (listed below) will fit great together and on your 2010 Honda Accord Crosstour with the naked roof. Inno Roof Rack - Aero Crossbars #INXB130-138 - Through Feet #INXS250 - Fit Kit #INK587 The…

view full answer...

Answer 6

According to Rhino Rack, if you were to go with the shorter bars, you'll only have 1-1/4 inch of leeway on each side which isn't enough in their opinion. I'd recommend going with the 71 inch bars so you'll be certain of a good fit. As…

view full answer...

Answer 7

The B&W Companion OEM 5th Wheel Hitch w/ Slider for Chevy/GMC Towing Prep Package #BWRVK3775 you're looking at will work fine with your new Chevrolet Silverado. This hitch has 3 height adjustments so you'll be able to set the hitch height…

view full answer...

Answer 8

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 9

The Thule TracRac CapRac Ladder Rack for Camper Shell/Truck Cap #TH29200XT is not actually meant to be installed into top tracks. This crossbar system is actually meant to be installed in fixed points on your camper shell so it's not going to…

view full answer...

Need Larger Diameter Replacement End Caps for Yakima Round Crossbars

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching