Troubleshooting Curt Trailer Wiring C56344 That Flashes Vehicle Brake Lights Then Shuts Them Off
Question:
My fiancé purchase the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector Item # C56344. I installed it following the instructions provided. Now the tail lights flash 4 times and turn off when the brake is pressed.
asked by: Kyle M
0
Expert Reply:
That is definitely not a good sign but it's most likely that you just need to unplug all of the connectors and plug them back in to clear any possible connector seating issues. Also make sure the power wire is connected to your battery and the fuse is good and installed.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Interior RV Light Recommendation to Replace Liteco 179 Interior Light
- Q&A: Towing Capacity for 2016 Jeep Compass
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Q&A: Will the Curt Trailer Wiring Harness for a 2015 Jeep Compass Kill the Battery With Trailer Unplugged
- Q&A: Tongue Weight Capacity of a Class III Draw-Tite Trailer Hitch for a 2011 Jeep Compass
- Q&A: Installing a Brake Controller in a 2004 Fleetwood Southwind 32VS with Factory 7-Way
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Installation Instructions for Reese Dual Cam Weight Distribution System
- Q&A: Factory Brake Controller Port Location on 2011 Nissan Titan
- Article: Rooftop Cargo Carriers
- Article: Best Air Bag Suspension (2023)
- Article: Trailer Jacks
- Article: 7 Common Questions Everyone Has About Trailer Tires