Where To Install Load Resistors On 2006 Range Rover That Only Hyperflashes w/ Trailer Connected
Question:
My vehicle 2006 Range Rover has incandescent bulbs and my cargo trailer has led’s. When the trailer is NOT connected the turn signals blink normally. When the trailer is connected they hyper flash. If I install load resistors, do I install them on the trailer or the vehicle ?
asked by: Mike
0
Expert Reply:
You're going to want to install the resistors # DI34ZR on each of your lighting circuits, the right turn/stop, left turn/stop, and running lights.
You'll need two of these kits to get this installed on your trailer, and this will fix the hyperflash issue you're having.
expert reply by:
Samuel C
0
Product Page this Question was Asked From
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Continue Researching
- Q&A: Solution for Rapid Signal Flashing on Utility Bed with LED Lights
- Q&A: Are Load Resistors Required when Adding LED Lights to a Trailer
- Q&A: Are Load Resistors Needed for LED Backup and Brake/Tail Lights
- Q&A: What Is The Depth Of The Ventline Pinnacle Ductless RV Range Hood VE78SR
- Q&A: How Do I Install Load Resistors for the LED Lights on my 2007 Dodge 3500 Flatbed
- Q&A: LED Tail Lights Added to Flat Bed Truck Hyper Flash with Flashers/Turn Signals On
- Q&A: Recommended Load Resistor Adapter for Furrion Observation Camera on Travel Trailer for Signal
- Article: Top Weight Distribution Hitches for a Buttery Smooth Ride
- Article: Gooseneck to 5th Wheel Adapters
- Article: Trailer Wiring Diagrams
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Article: Best Boat Accessories
- Article: Which Hitches are Made in the USA
- Article: Most Popular Wheel Bearings