Can Cables Be Extended on NOCO GENPRO On-Board Battery Charger
Question:
Can I extend the eyelet cable length using an appropriate wire gauge?
asked by: Peter
0
Expert Reply:
Yes, you can extend the cables with the eyelets on the # NOC44FR. The 14AWG leads can be extended an additional 10' without modifying or moving the fuse. The fuse must remain in place and the additional length must be added after the fuse. Assuming you follow these guidelines you will not void the warranty.
expert reply by:
Robin H
0
Product Page this Question was Asked From
NOCO GENPRO On-Board Battery Charger - AC to DC - Waterproof - 1 Bank - 12V - 10 Amp
- Battery Charger
- Battery Charger
- Boat
- Electric Vehicle
- Generator
- Trolling Motor
- 230 Ah
- Charges/Maintains
- 12V
- Wall outlet to Vehicle Battery
- NOCO
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: X-Connect Extension Cable for NOCO Genius Battery Chargers - 10' Long
- Video: Review of NOCO Battery Charger - 10-amp Submersible Battery Charger - NOC44FR
- Q&A: Extending the Charger Lead Wires on NOCO Genius Battery Charger
- Q&A: Can Two 12 Volt Batteries Connected in Parallel be Charged Through a Switch Using a NOCO Charger
- Q&A: Replacing Axles Brakes And Hubs On A 1998 Carson Enclosed Trailer
- Q&A: How To Charge 2-6v Batteries Wired In Series on Truck Bed Camper and Which Charger to Use
- Q&A: How to Keep House Batteries on Slide-In Truck Camper Charged
- Q&A: Recommendations for Charging Small Trailer Battery with DC and AC power
- Article: Trailer Wiring Diagrams
- Q&A: Troubleshooting Low Propane Pressure
- Article: Most Popular Wheel Bearings
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Choose a Battery Charger
- Article: How to Replace or Install an RV Roof Vent
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: Diode Installation Instructions for a Dinghy with Separate Tail Light Wiring