Replacement Control Module For A Kwikee 40-Series RV Electric Step

Question

Question:

Hi Im looking for the replacement control module part # 909513 for the 40 series step. Would you have parts like that or a lead where to find a replacement compatible

asked by: Joe

0

Expert Reply:

According to Lippert's replacement charts the correct control module for a 40-Series step is the Replacement Control Unit for Kwikee Electric RV Steps # LC379146.

expert reply by: Kevin C

0

Answer 1

The Replacement Control Module for Lippert Electric Coach Step #LC301702 is the correct fit for your Lippert Coach step. The long green wire with the ring terminal is your ground and will be attached bare metal to metal on our coach frame. The short…

view full answer...

Answer 2

The clicking sound you are getting of your coach step seemingly wanting to over extend or over retract is not a motor issue but rather a control module issue. This is basically the brains of the operation and if another item wasn't working…

view full answer...

Answer 3

Here's the recommended way to troubleshoot RV Coach Steps that aren't working properly. 1. Disconnect the plug between the chassis and the steps. Using a voltmeter, measure the voltage on the large red wire at the chassis connector with the…

view full answer...

Answer 4

If your RV step's motor is dead (no operation even if you bypass the switches and directly apply 12V power to the motor terminals) then it will require replacement. Your gearbox may still be okay so long as it has not made bad noises when it last…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 6

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 7

A 4-way trailer connector will have four functions which means it will also have four wires for the exception of wishbone harnesses. These four functions are ground, tail light, right turn, and left turn. The ground function will usually be…

view full answer...

Answer 8

It really just depends on what the wires are for. Most likely you have several ground wires among the 8 as well as a couple running light circuits in there as well. You just have to run all of the wires to the correct circuits. The 4-way wiring of…

view full answer...

Answer 9

There are indeed many different replacement step controllers out there and I am happy to re-confirm that the correct current item to replace your Kwikee step controller 1800709 is part #LC363989. I verified this item with my parts contacts at…

view full answer...

Replacement Control Module For A Kwikee 40-Series RV Electric Step

Product Page this Question was Asked From

Continue Researching