Routing Power Wire for T-One Vehicle Wiring Harness on 2015 Chrysler 200
Question:
Wiring harness installation on a 2015 Chrysler 200S all wheel drive: I reviewed the instructions on the website however the instructions lack guidance and how to run a hotwire from the trunk to the battery. Do you have any suggestions on resources that might indicate the best way to do this?
asked by: Chad O
Expert Reply:
Yes, the power wire routing instructions for a trailer wiring harness like the Curt T-connector # C56242 for a 2015 Chrysler 200 are usually pretty generic as there are more than one way to route the wire. I don't have exact instructions for you unfortunately as the manufacturer does not provide any and we have not yet done this on this vehicle. That said, I recommend first finding a grommet in the trunk pan to route the wire through and then once you get it outside the vehicle, following the brake lines up into the engine bay where the battery is and that should get you home.
Products Referenced in This Question
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Trailer Hitch that is Mostly Hidden for a 2015 Chrysler 200
- Q&A: Parts to Tow a Small Trailer with a 2015 Chrysler 200