Will The Replacement Sidewind Handle Kit # F0933305S00 Fit Fulton Magnum Jack On 2002 Boat Trailer?
Question:
How can I find the part number for a Fulton magnum series? It was on a 2002 five star trailer for a 20 foot boat. I need a handle replacement. Is this the right part? Thank you!
asked by: Earl
Helpful Expert Reply:
With the Magnum series of Fulton jacks being obsolete you will want to disassemble your jack to verify if the handle shaft matches on the Replacement Sidewind Handle Kit # F0933305S00. Even with knowing the model number on your Jack it is difficult to get information from Fulton on compatibility as they just say if the part wasn't specific to that jack it will not fit. This handle is 1/2" in diameter and the roll pin for the gear is located 2-1/8" in on center from the end of the shaft. I have linked an image below with all the dimensions on the handle.
(click to enlarge)
Product Page this Question was Asked From
Replacement Sidewind Handle Kit for Fulton XP15 Series Marine Jacks
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Handles and Cranks
- Sidewind
- Fulton
more information >
Continue Researching
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Trailer Wiring Diagrams
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Replacement Lights and Trailer Harness for SnowBear Trailer
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Q&A: Replacement Sidewind Handle Needed for Fulton Magnum Series 1000 LB Jack
- Q&A: Diameter Of Replacement Sidewind Handle for etrailer and Ram Square, Direct Weld Jacks
- Q&A: Sleeve Washer for Fulton Swivel Jack to Prevent it From Leaning
- Q&A: Replacement Handle for Fulton Magnum Series Jack
- Q&A: Are 800 lb and 1,500 lbs Replacement Fulton Trailer Jack Handles Interchangeable
- Q&A: Replacement Bearing Kit for Snowbear Trailer with L44643 Bearings
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Best Boat Trailer Jacks
- Article: Trailer Tire Sizing