Over Under Conversion Kit for Tandem Axle Car Hauler
Question:
I have a double axle car hauler and would like to flip the springs so it rides higher. I use it behind and RV and the hitch will bottom out as well as the end at times. I looked at Item # K71-384-00. I would probably need 2. Also does this need to be welded? Thanks!
asked by: Steven Z
Expert Reply:
The Dexter Trailer Springs Over-Under Conversion Kit # K71-384-00 is the correct part for your car hauler if you have 2-3/8" diameter axles. If you have a 3" axle then you need the # K71-385-00 instead. You will need two kits, one per axle. This does not require welding for installation, check out the installation video below so you can see what the process is like.
Products Referenced in This Question
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Leaf Spring Suspension
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 3 Inch
- Dexter
more information >
Product Page this Question was Asked From
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Leaf Spring Suspension
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 2-3/8 Inch
- Single Axle
- Dexter
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Raise Your Travel Trailer Height
- Article: Trailer Tire Sizing
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Double-Eye Trailer Suspension System Review
- Article: Slipper Spring Trailer Suspension System Review
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Dimensions for the MORryde ALLTREK 4000 Suspension Kit
- Q&A: Breaking In Replacement 6,000 lbs Leaf Springs
- Q&A: Recommended Lift Kit for 2021 Forest River Gray Wolf Travel Trailer
- Q&A: Can 3,500 lb Axle Trailer Leaf Spring 25-1/4 inch get Replaced with 5k Rated Spring
- Article: Trailer Wiring Diagrams
- Q&A: What Leaf Spring Width SHould be Used with Dexter Over Under Kit # K71-384-00
- Q&A: How to Increase Trailer Ground Clearance Using an Axle Over-Under Kit
- Q&A: Would Dexter 3,500 lb Axle Made in 1999 Use Same Hubs as Current