Can Valterra Waste Valve T58 be Upgraded so that it's Permanent Install
Question:
I’m currently using the Valterra t58 twist on valve. I’d like to upgrade to a permanent valve. Can I swap the twist on fitting and install the t1005 slip fitting on my existing valve?
asked by: Joshua F
0
Expert Reply:
Yes, you could remove the twist on side of the Valterra Waste Valve part # T58 that you have now and replace it with the part # T1005 so that you could make it more permanent like you are wanting.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Valterra RV Sewer Slip Hub with Flange - 3"
- RV Sewer Hose Fittings
- Sewer Seals and Gaskets
- Slip Hubs
- Hub
- Sewer Pipe to Waste Valve
- 3 Inch Diameter
- Valterra
more information >
Continue Researching
- Q&A: Wiring Diagram for Advent Air Conditioner ACM135
- Article: Replacement Automotive Lighting
- Article: How to Wire an Electric Winch
- Q&A: What Size Trailer Frame Will the Replacement Weight Distribution Chain Hangers Fit On
- Q&A: Can MORrude Rubber Equalizers MR87ZR Be Used On Trailer With 6000lb Axles?
- Q&A: Thermostat Wiring Diagram for Advent AC Unit part # ACM135B
- Q&A: Replacement RV Air Conditioner for Dometic 459516.701C0
- Q&A: Recommended Waste Hose Setup For A Flagstaff E-Pro E12RK Travel Trailer
- Q&A: Recommended Replacement for the Parallax 7455T
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Replace a Rubber RV Roof
- Article: How to Install an RV Awning From Scratch
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Choose a Battery Charger