What Size Water Lines Are Needed For The Flow Max RV Fresh Water Pump # LC689054
Question:
Im thinking about using this pump in my boat for the potable water system. What size tubing ID are the barb fittings intended for? My waterlines are 1/2. Thanks!
asked by: Ron
0
Expert Reply:
The Flow Max RV Fresh Water Pump # LC689054 requires flexible pipe/tubing that is a minimum of 1/2" inner diameter reinforced hose, so you should be good to go. Just make sure you pick up a couple of hose clamps from your local hardware store in order to secure the lines to the barbed fittings.
expert reply by:
Kevin C
0
Product Page this Question was Asked From
Flow Max RV Fresh Water Pump - 115 Volt - 3.3 Gallons Per Minute - 45 PSI
- RV Water Pump
- Diaphragm Pump
- 3.3 gpm
- 45 psi
- 140F
- 60C
- 115V
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Is There Solution for Furrion RV Fireplace that Circuit Board is Broken
- Q&A: Shipping Weight of Dexter Trailer Axle T20BTR-EZ-7258
- Q&A: Troubleshooting Furrion 30" RV Electric Fireplace That Will Not Turn On
- Q&A: Does Furrion RV Electric Fireplace FF30SC15ABL Need A Dedicated Circuit?
- Article: Best RV Roof Vents
- Q&A: Adapter Fittings, Tubing, and Clamps for Atwood Water Heater
- Q&A: Troubleshooting One Tire Wearing Out on a Tandem Axle Trailer
- Q&A: Recommended Water Pump for An RV Using A Lot of Water
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: How Does an RV Water Pump Work?
- Article: 2 Steps for Hooking Up an External Propane Tank to Your RV
- Article: Ram Trailer Tow Prep Package
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: What is Overlanding? How to Start your Overlanding Journey