How to Remove Rear Taillights on a 2012 VW Routan to Install Tow Ready Trailer Wiring # 118490
Question:
I just received part #118490 from you for my 2012 VW Routan. The first step in the instructions is to remove T30 bolts on the tail lights. I couldnt find these on my van. I found some regular bolts though. I removed them and the tail light was then loose, but I couldnt pull it out. How do I get the tail light out?
asked by: Brian G
0
Expert Reply:
You removed the correct bolts already, it looks like on your vehicle the bolts where regular hex bolts and not the Torx bolts. The next step is to gently pry the light assemblies rearward away from the vehicle being careful not to break the alignment tabs.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Measure for Trailer Hitch Drop
- Q&A: How to Replace a 4-Way Trailer Connector with 8 Wires
- Q&A: Replacement Brake Shoes for Dexter 12k Axles
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Performance Chips and Modules
- Q&A: What Oil Should be Used in Dexter Oil Bath Hubs
- Q&A: Replacement Trailer Dust Cap/Cover for Dexter 21-88