Will SPST 50 Amp Pollak Heavy-Duty Toggle Switch Fit 1/2 Inch Plywood
Question:
Need a SPST 12 V DC 50 Amp switch but need to mount in in a 1/2 inch CDX plywood piece. Will this Switch work? If not, do you have one that will mount in 1/2 inch plywood? Thanks.
asked by: Tom L
Expert Reply:
The threaded portion of the Pollak Heavy-Duty Toggle Switch # PK34212 you're looking at is about 1/2" long so in order to install this into a 1/2" of plywood you'll need to round out the plywood some.
Aside from this the only other toggle switch that matches what you're looking for is the part # PK34213 but the only difference is that it comes with a 1-1/2" handle instead of a 1" handle.
![Jon G](https://images.etrailer.com/static/images/catg/people/1086_tn.jpg)
Products Referenced in This Question
Pollak Heavy-Duty Toggle Switch - SPST- On-Off - 12 Volt - 50 Amp - 1.5" Handle
- Accessories and Parts
- Wiring
- Switches
- Toggle Switch
- 50 Amp
- Pollak
more information >
Product Page this Question was Asked From
Pollak Heavy-Duty Toggle Switch - SPST- On-Off - 12V DC - 50 Amp - 1" Handle
- Accessories and Parts
- Wiring
- Switches
- Toggle Switch
- 50 Amp
- Pollak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Availability Of Adapter To Go From 1-1/4" Hitch To A 2" Hitch
- Q&A: Replacement Landing Gear Jack for Ram Follow 12k Jack on Trailer
- Q&A: Polar Paddle Handle Locking Latch with Release Installation
- Q&A: How To Wire Dome and Third Brake Light On Leer Camper Shell
- Q&A: Best Replacement for Atwood 82543 Brake Actuator
- Q&A: How To Power Third Brake Light On Camper Shell Using 7-Way Trailer Connector
- Q&A: Troubleshooting A Demco Recon Gooseneck-to-5th Wheel Hitch Adapter
- Article: How to Install E-Track in 3 Easy Steps
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Rent an RV
- Article: Stability Control for Heavy Duty Vehicles
- Article: Trailer Wiring Diagrams
- Article: Must-Have Flat Towing Components