Does Draw Tite Hitch # 75751 Fit 2011 Ford Escape with Factory Hitch and Full Size Spare
Question:
I’ve got a 2011 Ford Escape with oem 1.5 hitch ,rear sensors and 235-70-16 full size spare. Will the75751 hitch fit over the existing oem hitch and will it fit over my full size spare?
asked by: Tom B
1
Helpful Expert Reply:
Yes, the Draw Tite hitch part # 75751 does fit your 2011 Ford Escape that has the factory hitch and a full size spare so it would work great for you. It will make the install easier if you temporarily drop the spare but it will go back up once the hitch is installed.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 675 lbs TW
- 4500 lbs GTW
- 5250 lbs WD GTW
- 2 Inch Hitch
- 675 lbs WD TW
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Brake Assemblies and Hub/Drums for 15k Dexter Axle
- Q&A: Recommended Square Bulldog Jack with 5,000 lb Capacity
- Q&A: Replacement Trailer Wheel for Dexstar Wheel 17-293
- Q&A: No Turn or Brake Signals on Trailer on a Jeep Liberty with Tow Ready Harness 118524
- Q&A: Trailer Tire Wear on Right Side, Outside Tread Only and Trailer Pulls Hard to One Side
- Article: Trailer Tire Sizing
- Article: Replacement Automotive Lighting
- Q&A: Determining Replacement Hub And Bearings For Dexter P-12 SLR Trailer Axle
- Q&A: Best Track System for a Roof Rack on a NuCamp T@G Camper
- Article: Determining Trailer Tongue Weight
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices