Leg Tube Dimensions and Pin Hole Diameter of etrailer Jack # TJD-5000S
Question:
What is the size of the leg tube and what size are the holes?
asked by: Darren N
1
Helpful Expert Reply:
The tube width of the drop leg that comes with the etrailer jack # TJD-5000S that you referenced is 1-3/4 inch square and the diameter of the pin holes is 5/8 inch.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Square Direct Weld Jack w/ Footplate - Drop Leg - Sidewind - 28-3/4" Lift - 3,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 2001 - 3000 lbs
- Sidewind Jack
- 29 Inch Lift
- Weld-On
- With Rectangle Foot
- etrailer
more information >
Continue Researching
- Q&A: Trailer Jack for Trailer With Non-Traditional Trailer Tongue
- Q&A: Brainstorming Sidewind Trailer Jack for 2 Inch Receivers On Cargo Trailer Corners For Stabilization
- Q&A: Measurements on the Channel Tongue Trailer Coupler
- Q&A: Recommended Support Jacks for Rear of Tandem Axle Dump Trailer
- Q&A: What Does Code L. Mean on Curt Triflex Brake Controller
- Q&A: Replacement Hub and Drum assembly for ALKO 8480
- Q&A: Wiring Diagram for the Bulldog Winch Switch BDW20261
- Article: Where to Position the Trailer Axle?
- Article: Trailer Couplers
- Article: Trailer Wiring Diagrams
- Article: Trailer Jacks
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Parts Required to Add Electric Over Hydraulic Drum Brakes to a Trailer
- Article: Trailer Tire Sizing