How To Install the Wheel Bearings On The ARK Trailer Jack # ORJW350D
Question:
what is the best way to install the bearings on the wheel of the XO350 Ark jack?
asked by: Ella
0
Expert Reply:
The bearings for the Xtreme Off-Road Swing-Up Trailer Jack # ORJW350D need to be pressed into the wheels. It is possible to use a socket and dead blow hammer to get them in the hub, but be sure to support the wheel when doing so to not damage the parts. A trick to aid in the installation is to put the bearings in the freezer which will actually shrink them slightly and will allow them to go in easier. If you have access to a press this is the ideal method for installing the bearings.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Ark Xtreme Off-Road Swivel Trailer Jack w/ 2 Wheels - Sidewind - 12" Lift - Zinc - 770 lbs
- Trailer Jack
- Boat Trailer
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 0 - 1000 lbs
- Sidewind Jack
- Swivel Jack
- 7 Inch Lift
- Bolt-On
- With Wheel
- Ark
more information >
Continue Researching
- Q&A: Overall Length When Retracted of the Extreme Off-Road Swing-Up Trailer Jack w/ Dual Wheels
- Q&A: Extreme Off-Road Swing-Up Jack for a T@B 400 Tear Drop Trailer
- Q&A: Recommended Extreme Off-Road Swing-Up Trailer Jack for Intech Flyer Pursue
- Q&A: Dimensions Of Mounting Plate For Xtreme Off-Road Swing-Up Trailer Jack # ORJW750BD
- Q&A: Does Xtreme Off-Road Trailer Jack Come With Bearings Installed
- Q&A: Mounting Bracket Dimensions For Ark Extreme Off-Road Swing-Up Trailer Jack ORJW350D
- Q&A: Recommended Replacement to Replace a Bulldog 160 Series Jack
- Article: How to Measure for Trailer Hitch Drop
- Article: What Exactly is Tongue Weight?
- Article: Trailer Wiring Diagrams
- Article: Big Truck Big RV
- Article: Determining Trailer Tongue Weight
- Article: Pintle-Hitches
- Article: Trailer Lighting Requirements