Can the Ramp Spring # RS16933LH Be Heated Up and Bent?
Question:
Can the spring be heated up and bent? The springs will not fit on my trailer without preloading the spring. If preloaded the ramps can not be adjusted in and out for width.
asked by: Brendon P
0
Expert Reply:
By heating up the Ramp Spring # RS16933LH you do risk damaging the tension in the spring steel.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Ramp Spring - 2K Torque for 1-1/2" Round Shaft - LH
- Trailer Ramp Springs
- Single Ramp Spring
- Left Hand Spring
- 11 Inch Wide Spring
- Steel Alloy
- Redline
more information >
Continue Researching
- Q&A: Replacement Boat Trailer Seal for a NOK AD2527E Grease Seal
- Q&A: Can Trailer Tire Size 175/80-13 Replace Size 185/80R13
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: How to Choose Safety Chains for 12,000 lb Trailer
- Q&A: Determining Axle Length for 6 Foot 6 Inch Wide Trailer
- Q&A: How Do the Heavy Duty Ramp Springs Install on a Trailer and Ramp
- Q&A: Trailer Tire and Dual Wheel Recommendation for 10K Dexter Axle
- Article: Best RV Roof Vents
- Q&A: Replacement Grease Seal for Dexter 010-054-00 Seal
- Article: Trailer Wiring Diagrams
- Article: Trailer Maintenance Schedule
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Measure for Trailer Hitch Drop