E-Bike Rack Recommendation for 45 lb Momentum E-Bike

Question

Question:

Would you recommend a roof bike rack for an momentum electric bike that weighs 45lbs. Fork mount is OK, this bike does have fenders front and rear. Thank you.

asked by: Sal V

0

Expert Reply:

The Kuat Trio roof rack part # TR02 is a fork mounted roof bike rack that has a 45 lb weight capacity which would work great with your Momentum e-bike.

expert reply by: Jameson C

0

Answer 1

We do have the replacement rubber strips for the Thule WingBar Evo crossbars, and like you said they are in fact different than the AeroBlade. The correct part for your WingBar crossbars is the following: - Replacement QuickAccess Interface Top…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

There shouldn't be another washer on the Replacement Red Knob for Yakima Frontloader Fork Mount Bike Carrier #8880226. That appears to be part of the internal threads on the red knob itself. To replace this piece you'll just have to replace…

view full answer...

Answer 7

Yes, the Thru-Axle Skewer Adapter for Yakima WheelHouse Bike Tire Carrier #Y02110 that you mentioned will work fine with your Yakima HighSpeed #Y02115. This adapter will replace your wheel's thru-axle skewer and will slide into the carrier's…

view full answer...

Answer 8

I have an answer for you. Unfortunately, we do not carry any roof bike racks that are rated with a greater maximum weight capacity than the 50-pound limit on the Inno Tire Hold II Roof Bike Rack - Wheel Mount - Clamp On #INA389. Also, even if we did…

view full answer...

Answer 9

The Tire Linc TPMS for RVs and Trailers part #LC37VR comes with a repeater dock which will be used to power the repeater. However, if you have a model that is setup for this system then there will already be a repeater dock installed and wired up so…

view full answer...

Answer 10

The front mounting hardware for the Kuat Trio #RU01 uses tamper-resistant parts. A would-be thief would have to have the exact tool to remove the rack from the roof. Upon realizing this a would-be thief would move on to an easier target.

view full answer...

Answer 11

The Yakima OnRamp E-Bike Platform Bike Rack with Ramp - 2" Hitches #Y36FR has a measurement of 9" from the hitch pin hole to the nearest part of the bike rack. You can compare this with your travel trailer and that will determine if it will…

view full answer...

Answer 12

The best hitch will depend on the distance between the camper's frame members at the rear bumper area. If the camper is equipped with a bumper, you'll also need to be concerned with the drop that the hitch provides, which is the vertical…

view full answer...

E-Bike Rack Recommendation for 45 lb Momentum E-Bike

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching